Belt Or Brushroll: Removal & Replacement - Dirt Devil Vacuum Cleaner Owner's Manual

BELT OR BRUSHROLL: REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS OR FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE CHANGING BELT OR
BRUSHROLL.
BELT STYLE
5
For Belt Style 5 replacements, please visit our website at www.dirtdevil.com to buy
online or call customer service at 1-800-321-1134.
TO REMOVE BELT
2.
1.
Lay cleaner flat and flip cleaner Lift nozzle guard off.
to expose nozzle base. Base
should lay flat and face up.
To remove nozzle guard, use
Phillips screwdriver to remove
the four (4) screws. Arrows
show location of screws.
TO REPLACE BELT OR BRUSHROLL
5.
4.
END CAP
Lift and remove brushroll. Place new belt in area of
Dispose of old belt. brushroll without bristles.
7. 8.
7a.
With new belt in place, pull and
Reattach nozzle guard.
slide brushroll into nozzle mak-
ing sure that the brushroll end
caps are in the correct orientation
(7a inset). Rotate brushroll manu-
ally to make sure belt is properly
aligned.
3.
Slide belt off motor shaft.
6.
Slide belt onto motorshaft.
9.
TAB TAB
Secure by aligning the three
(3) tabs in the base slots. Be
sure to replace all four (4)
screws.
10
TAB