Digital Room Thermostat (Dts92) - Honeywell ATC928G3000 Manual

Wi-Fi evohome Controller
(ATC928G3000)
To bind a Digital Room Thermostat (DTS92) to a Wi-Fi evohome Controller
(ATC928G3000) as the room temperature sensor in a zone...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press ZONE CONFIGURATION
3
Press on the required zone
4
Press TEMPERATURE SENSOR
5
Press REMOTE SENSOR
6
Press the green tick
7
On the Digital Room Thermostat
Press and hold for 2 seconds
8
to put the unit into standby
6
Wireless connectivity Guide
for 5 seconds
Digital Room
Thermostat (DTS92)
Press and together for 3
9
seconds – it should display 'INst'
Press – it should display 'COnt'
10
Press three times – it should display 'CLr'
11
Press once to clear any previous binding data
12
Press – it should display 'COnt'
13
Press once to send the binding
14
signal to the evohome Controller
You should receive a SUCCESS message on the
evohome Controller. If not go back and re-bind.