Wireless Cylinder Thermostat (Cs92) - Honeywell ATC928G3000 Manual

Wi-Fi evohome Controller
(ATC928G3000)
To bind a Wireless Cylinder Thermostat (CS92) to a Wi-Fi evohome
Controller (ATC928G3000) to control a hot water cylinder...
On the evohome Controller
Press and hold SETTINGS
1
Press the green tick
2
Press SYSTEM DEVICES
3
Press STORED HOT WATER
4
Press ENABLED
5
Press HOT WATER SENSOR BINDING
6
14
Wireless connectivity Guide
for 5 seconds
Wireless Cylinder
Thermostat (CS92)
On the Wireless Cylinder Thermostat
Press and hold the button for 5
7
seconds. The green light should come
on and the red light should flash
Press the button again
8
You should receive a SUCCESS message on
the evohome Controller and the LED on the
Wireless Cylinder Thermostat should stop blinking
and turn OFF. If not, go back and re-bind.