Position And Time Programming - Icom IC-M92D Instruction Manual

8
DSC OPERATION

Position and time programming

■
A Distress call should include the ship's position and time
data. If no GPS is connected, your position and UTC (Univer-
sal Time Coordinated) time should be manually input. They
are automatically included when a GPS receiver compatible
with the NMEA0183 ver. 2.0 or 3.01 format is connected.
• Manual programming is disabled when a GPS receiver is
connected.
• Manually programmed position and time data will be held
for only 23.5 hours.
Enter "POSITION INPUT" in the DSC SETTINGS menu.
q
➪
MENU
(Push [MENU])
Edit your latitude and longitude position data using Dial, or
w
[Y]/[Z]/[Ω]/[≈].
• Select a desired number using Dial, or [Y]/[Z]/[Ω]/[≈].
• Push [ENT] or Dial to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT].
• Select N: North latitude or S: South latitude when the cursor is
on the 'N' or 'S' position.
• Select W: West longitude or E: East longitude when the cursor
is on the 'W' or 'E' position.
23
DSC Settings ➪ Position Input
(Push [Y]/[Z], then push [ENT].)
After entering the position data, push [ENT] to program it.
e
The UTC time programming screen is displayed, enter the
r
UTC time in the following way:
• Select a desired number using [Y]/[Z]/[Ω]/[≈].
• Push [ENT] to set it.
• To move the cursor, select either arrow, "←" or "→," then push
[ENT].
Push [ENT] to program your position and time data.
t
• Return to the "DSC SETTING" screen.