Alert Messages - Ricoh DDST A, DDST B Operating Instructions Manual

Troubleshooting

❖ Alert messages

Messages/Second messages
Change Tray # to the follow-
ing settings:
xxx yyy
Collate cancelled.
Collate: Page max.
5
Duplex cancelled.
Duplex mode is in off posi-
tion for Tray #
Ethernet Board Error
Exceeded max. print size.
Press FormFeed/JobReset.
I/O buffer overflow
Load paper in Tray #
34
Causes
The settings of the selected pa-
per tray are different from
those specified for printing.
# indicates the tray number.
xxx indicates the tray number.
yyy indicates the paper size.
The collate print function has
been canceled.
The maximum number of pages
has been exceeded for collation.
Duplex printing has been can-
celed.
The selected paper tray has
not been configured for du-
plex printing.
# indicates the tray number.
An error has occurred in the
Ethernet interface.
The page images to be printed
exceed the maximum print area.
The maximum size of the I/O
buffer has been exceeded.
There is no paper in the select-
ed paper tray.
# indicates the tray number.
Solutions
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to print regardless.
For details about the paper
tray settings, see General Set-
tings Guide.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Turn off the main power
switch, and back on again. Re-
duce the number of pages to
be printed, or, increase memo-
ry capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Check the paper used is suita-
ble for duplex printing, or, in-
crease memory capacity.
When installing a memory
module in the machine, con-
tact your sales or service rep-
resentative.
Press [JobReset] to change the
paper tray settings, or do sin-
gle-sided printing.
For details about the tray set-
tings, see General Settings Guide.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
Press [JobReset] to change the
paper tray settings, or press
[FormFeed] to print regardless.
Increase the size of the I/O
buffer through the Host Inter-
face menu.
Load the tray with paper.