Konica Minolta bizhub PRO 1100 Quick Manual page 59

P
Select whether to continue the scan
measurement or to finish the scan
measurement and calculate the
adjustment value.
-
To continue the scan measurement, press
[No]. To finish the scan measurement and
calculate the adjustment value, press [Yes].
-
Pressing [No] returns to the [Scan
Adjustment Chart] screen on which the
counter of [Chart Sheets] is added by one.
Repeat steps 12 to 15 for the number of
adjustment charts. The measurement results
will be added up. This operation can be
repeated up to 20 times. When the 20th scan
measurement is completed, [No] can no
longer be pressed.
- Pressing [Yes] automatically calculates the
adjustment value from the added
measurement results and reflects it on Zoom
and Image Shift to be specified for [Back].
After pressing [Yes], output a sheet of the
adjustment chart to confirm the result. If
readjustment is needed, repeat steps 8 to 16.
- If the adjustment value obtained by pressing
[Yes] exceeds the available adjustment
range, a message is displayed indicating that
the available adjustment range has been
exceeded. Press [Close] to discard the
adjustment value, then retry scan
measurement from the beginning.
- Possible causes to exceed the adjustment
range may include that the chart used in the
scan measurement is incorrect (a different
chart has been used), the printing position of
the front side has been poorly adjusted, or
the adjustments of the reference positions
are not completed. Confirm these points
before restarting the scan measurement.
Q
After the adjustment is completed, press
[OK].
To finely adjust the adjustment value,
continuously proceed to step 4 in "Zoom and
Image Shift Adjustment" (page 5-23).
bizhub PRO 1100
5
5-9