Important Safety Information - Greenlee Quick Draw 7804SB Service Manual

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for
preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL
result in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information in
this manual before operating or
servicing this tool. Refer also to the
instruction manual, which is listed
under "Other Publications."
Failure to observe this warning can
result in severe injury or death.
Electric shock hazard:
Do not use this tool near live circuits.
This includes, but is not limited to,
the following:
• Near circuit breaker panels or fuse
boxes with energized circuits
• Near junction boxes with ener-
gized circuits
Failure to observe this warning can
result in severe injury or death.
Greenlee Textron / Subsidiary of Textron Inc.
®
Quick Draw Hydraulic Punch Drivers
SAFETY
ALERT
SYMBOL
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris.
• Inspect tool for wear or damage. Replace any
worn, damaged, or missing components with
Greenlee replacement parts. A damaged or
improperly assembled tool can break and strike
nearby personnel with sufficient force to cause
severe injury or death.
• Inspect the punch, die, draw stud, and spacers for
wear or damage. Replace any worn or damaged
items with Greenlee replacement parts. Replace
any punches that have dull cutting surfaces.
Do not exceed the rated capacity of this tool.
Exceeding the rated capacity could cause a
component failure, which could throw broken parts
with great force.
Failure to observe this warning can result in severe
injury or death.
Do not operate the pump lever after the ram motion
stops. Continuing to operate the pump lever after the
ram motion stops will damage the driver and could
propel internal parts with great force, striking nearby
personnel.
Use this tool for the manufacturer's intended pur-
pose only. Use other than that which is described in
this manual can result in injury or property damage.
Note: Keep all decals clean and legible, and replace
when necessary.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815/397-7070