Adjusting The Fusing Temperature Manually - Ricoh FW770 Operating Instructions Manual

Copy Settings

Adjusting the Fusing Temperature Manually

A
Press the { { { { Copy Media} } } } key to turn on the Translucent or Film indicator that
you want.
3
B
Hold down the { { { { Copy Media} } } } key for 3 seconds until beep. The indicator
show the current fusing temperature. The unlit indicator shows the current
temperature settings.
C
Press the { { { { i
increase the temperature. The number of temperature levels (7 levels)
available depends on the paper type:
• Plain paper : 1234567
• Translucent paper: 1234
• Film : 1234
D
After you have finished setting the temperature, press the { { { { Copy Media} } } } key.
E
Choose any copy settings you require, and then start copying.
Note
The new fusing temperature for the selected paper type is cleared when
you press the {Clear Modes/Energy Saver} key or turn off the main switch.
28
i } } } } key to decrease the temperature, and press the { { { { j
i i
j } } } } key to
j j