Using Show Commands To Verify Sip And Spa Status; Using Show Commands To Display Spa Information - Cisco XR 12000 Series Hardware Installation Manual

Chapter 5 Installing and Removing a Shared Port Adapter
•
•
Note
Step 3 If the SIPs and SPAs have not become active within three minutes, refer to the system console messages
as follows:
•
•

Using show Commands to Verify SIP and SPA Status

The following procedure uses show commands to verify that the new SPAs are configured and operating
correctly.
Use the show running-config command to display the system configuration. Verify that the
Step 1
configuration includes the new SPA interfaces.
Display all of the current SPAs and a summary of their status using the show hw-module subslot oir
Step 2
command.
Display information about the installed SIPs using the show diag command.
Step 3
Use the show hw-module subslot fpd command to verify the FPD version information of the SPAs
Step 4
installed in the system.
Note
Step 5 Finally, you can use the show version command to obtain a few details on the installed SIPs and
interfaces available.

Using show Commands to Display SPA Information

Table 5-1
OL-17438-04
If a SIP or SPA is replaced with a module of the same type (as in an OIR or hardware swap), the
previous configuration will be reinstated when the SIP or SPA becomes active.
If a SIP or SPA has not been previously installed in the same slot or subslot, then the configuration
for all associated interfaces will be empty.
New interfaces are not available until you configure them.
If a SIP or SPA is undergoing an FPD upgrade, then console messages will indicate that the FPD
process has been initiated. The upgrade process might take several minutes. Use the show fpd
upgrade process command to obtain information about the FPD process. SIPs or SPAs that undergo
an FPD upgrade will automatically be rebooted. Return to
If there is no indication that an FPD upgrade is underway, see
Installation."
If a SPA does not meet the minimum version required, it will automatically be updated. If the
update fails, the failing module will be powered down and an error message will be reported on
the system console.
describes the show commands you can use to display SPA information.
Cisco XR 12000 Series Router SIP and SPA Hardware Installation Guide
Checking the Installation
Step 1.
Chapter 6, "Troubleshooting the
5-5