Spas Supported On The Cisco 10000 Series Spa Interface Processor-600; Identifying The Location Of A Cisco 10000 Series Spa Interface Processor-600 - Cisco uBR10012 Hardware Installation Manual

Overview of SPA Interface Processors

SPAs Supported on the Cisco 10000 Series SPA Interface Processor-600

Table 14: SPAs Supported on the Cisco 10000 Series SPA Interface Processor-600
SIP
Cisco 10000 Series SPA Interface Processor-600

Identifying the Location of a Cisco 10000 Series SPA Interface Processor-600

This section describes how to specify the physical locations for a Cisco 10000 Series SPA Interface
Processor-600 and its SPAs on the Cisco uBR10012 router within the command-line interface (CLI) to
configure or monitor these devices.
Specifying the Slot Location for a Cisco 10000 Series SPA Interface Processor-600
The Cisco 10000 Series SPA Interface Processor-600 is a full-height line card that occupies two physical slots
in a Cisco uBR10012 router. Each chassis supports a maximum of two SIPs that can be inserted in the following
slots:
• SIP slot 1
• SIP slot 3
Some commands allow you to display information about a SIP and its SPAs, such as the show inventory and
show diag commands. For example, to display information about the SIP installed in chassis slot 1 and its
SPAs, use the show diag command.
Specifying the SPA Location in a Cisco 10000 Series SPA Interface Processor-600
A Cisco 10000 Series SPA Interface Processor-600 supports four bays (subslots) for the installation of SPAs
and the SPA bays are numbered from 0 to 3. The number for each SPA bay is indicated by a small numeric
label on the SIP faceplate.
SPAs Supported on the Cisco 10000 Series SPA Interface Processor-600
Cisco uBR10012 Universal Broadband Router SIP and SPA Hardware Installation Guide
Supported SPAs
• Cisco 5-Port Gigabit Ethernet SPA
(PID—SPA-5X1GE-V2)
• Cisco 1-Port 10-Gigabit Ethernet SPA
(PID—SPA-1X10GE-L-V2)
• Cisco Wideband SPA (PID—UBR10-2XDS-SIP
• Cisco 3 Gbps Wideband Shared Port Adapter
(PID—SPA-UBR10-DS-HD)
• Cisco 6 Gbps Wideband Shared Port Adapter
(Effective with Cisco IOS Release
12.2(33)SCI1, the PID is SPA-UBR10-DS-6G)
In Cisco IOS Release 12.2(33)SCI, the
Note
PID is SPA-UBR10-DS-HD.
17