Verify Sm-X Installation - Cisco 4451 ISR Hardware Installation Manual

Chapter 6 Install and Upgrade Internal Modules and FRUs
Note
Step 5
Insert the screws from the accessory kit through the SM-X into the standoffs. See
the screws with a Phillips screwdriver (torque 6 to 8 in-lb or 0.7 to 1.1 Nm.).
Step 6
Check that the SM-X is installed correctly on the system board.
Note
For more details on installation of SM-Xs, NIMs, and Cisco E-Series Server Modules, see the hardware
installation guide for the particular module you have purchased.
For a list of links to all the SM-Xs and NIMs supported on your router, see the
for the Cisco 4000 Series

Verify SM-X Installation

Use the show diag command to verify that the SM-X is installed correctly. In the following example,
one SM-X is recognized by the system.
router#show diag ?
all
chassis
slot
subslot
Router#show diag subslot 2/0 eeprom detail
SPA EEPROM data for subslot 2/0:
OL-32185-02
Ensure to press firmly on the SM-X until the board is properly installed on the connector.
ISRs.
All related information
Chassis related information
Slot location information for this command
Subslot location information for this command
EEPROM version
Compatible Type
Controller Type
Hardware Revision
PCB Part Number
Top Assy. Part Number
Board Revision
Deviation Number
Fab Version
PCB Serial Number
Asset ID
Product Identifier (PID) : SM-X-1T3/E3
Version Identifier (VID) : V01
CLEI Code
Base MAC Address
MAC Address block size
Manufacturing Test Data
Environment Monitor Data : 40 0B E3 43 00 0A
Platform features
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Install and Remove NIMs and SM-Xs on Cisco 4000 Series ISRs
: 4
: 0xFF
: 1909
: 1.0
: 73-14154-02
: 800-36532-01
: 06
: 123598
: 02
: FOC15495HU1
: REV 2F
: TBD
: C4 0A CB 56 00 99
: 3
: 00 00 00 00 00 00 00 00
: 02 01 01 0A 00 00 00 00
01 01 00
Figure 6-27. Tighten
Documentation Roadmap
6-31