Trouble-Shooting And Maintenance - Weider WESY74090 User Manual

Trouble-shooting and Maintenance

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts
immediately. The home gym system can be cleaned using a damp cloth and mild non-abrasive
detergent. Do not use solvents.
Tightening the Cables
Woven cable, the type of cable used on the home gym
system, can stretch slightly when it is first used. If there is
slack in the Cables before resistance is felt, the Cables
should be tightened.
To tighten the Cables, insert the Weight Pin (26, not
shown) between the third and the fourth Weight, counting
from the top. See "Changing the Weight Setting" on page
17 for instructions on moving the Weight Pin.
Tighten the 3/8" Plain Nut (56) a few turns further onto the
3/8" Eyebolt (35) and then tighten the 3/8" Nylon Jamnut
(22) securing the Eyebolt to the Leg Lever (29). Repeat
this procedure until the Cables feel tighter.
Additional slack can be removed by moving the upper 3
1/2" Pulley (15) attached to the "I"-Plates (20) to the lower
hole. To do this, remove the 3/8" x 2" Bolt (12), Cable
Trap (66) and 3/8" Nylon Locknut (21). Move the Pulley
and re-attach it with the Bolt, Cable Trap and Locknut.
Make sure the Cable Trap is oriented as shown.
Note: If a Cable tends to slip off the Pulleys often, the
Cable may have become twisted. Remove the Cable
and re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
1
35
56
1
66
15
20
12
18
29
22
21