Trouble-Shooting And Maintenance - Weider 8507 User Manual

5. Press the Weight Tube Bumper (79) into the end of
the Weight Tube (80). Slide the Top Weight (77)
onto the Weight Tube. Be sure that the pins on the
Weight Tube are resting in the pin grooves under
the Top Weight.
Locate the Short Cable (23). Attach the Short
Cable to the Weight Tube (80) with a 5/16" x 1 1/2"
Bolt (24) and a 5/16" Nylon Locknut (3).
6. Lubricate the insides of the holes in the Top Weight
(77). Slide the Top Weight onto the stack of
Weights (25).
7. Press two 2" Square Inner Caps (27) into the Top
Frame (67).
Attach the Top Frame (67) to the Front Upright (42)
with two 5/16" x 2 3/4" Bolts (11), the Support Plate
(6), and two 5/16" Nylon Locknuts (3). Do not tight-
en the Nylon Locknuts yet.
Attach the Top Frame (67) to the Stop Bracket (63)
with a 5/16" x 2 3/4" Bolt (11), 5/16" Flat Washer
(8), and 5/16" Nylon Locknut (3). Do not tighten
the Nylon Locknut yet.
5
23
77
3
24
80
Pins
79
6
77
Lubricate
25
7
11
11
6
67
8
27
3
63
3
42
6

TROUBLE-SHOOTING AND MAINTENANCE

Inspect and tighten all parts each time you use the home gym system. Replace any worn parts immediately. The
home gym system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use solvents.
TIGHTENING THE CABLES
Woven cable, the type of cable used on the home gym
system, can stretch slightly when it is first used. If there
is slack in the cables before resistance is felt, the
cables should be tightened. Locate the adjustment
sleeve and adjustment screw near the lower end of the
Short Cable (23). Loosen the adjustment screw. Pull
the end of the Short Cable until there is no slack. Slide
the adjustment sleeve and the ball against the indicat-
ed 3 1/2" Pulley (15). Retighten the adjustment screw.
Make sure that the cables are not too tight, or the top
weight will be lifted off the weight stack.
27
15
Adjustment
Screw
Ball
Adjustment
Sleeve
23
19