Installation Standard Work Checklist - Heat & Glo 6000CLX-IFT-S Installation Manual

Installation Standard Work Checklist

This standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this
installation manual.
Customer:
Lot/Address:
Model (circle one): 6000CLX-IFT
WARNING! Risk of Fire or Explosion! Failure to install appliance according to these instructions could
lead to a  re or explosion.
Appliance Install
Veri ed that the chase is insulated and sealed. (Pg. 16)
Required non-combustible board is installed.
Veri ed clearances to combustibles. (Pg. 14-15)
Fireplace is leveled and secured. (Pg. 39)
Venting/Chimney Section 7 (Pg 40-45)
Venting con guration complies to vent diagrams.
Venting installed, locked and secured in place with proper clearance.
Elbow heat shield installed per requirements. (Pg 23, 33)
Firestops installed.
Attic insulation shield installed.
Exterior wall/Roof  ashing installed and sealed.
Terminations installed and sealed.
Electrical Section 8 (Pg 46-48)
Unswitched power (110-120 VAC) provided to the appliance.
Switch wires properly installed.
Gas Section 9 (Pg 49-50)
Proper appliance for fuel type.
Was a conversion performed?
Leak check performed and inlet pressure veri ed.
Veri ed proper air shutter setting for installation type.
Finishing Section 10 (Pg 51-55)
Combustible materials not installed in non-combustible areas.
Veri ed all clearances meet installation manual requirements.
Mantels and wall projections comply with installation manual requirements.
Appliance Setup Section 11 (Pg 56-66)
All packaging and protective materials removed (inside & outside of appliance).
Refractories, logs, Teco-Sil, and embers installed correctly.
Glass assembly installed and secured.
Accessories installed properly.
Decorative front properly installed.
Manual bag and all of its contents are removed from inside/under
the appliance and given to party responsible for use and operation.
Started appliance and veri ed no gas leaks exist.
Hearth & Home Technologies recommends the following:
• Photographing the installation and copying this checklist for your  le.
• That this checklist remain visible at all times on the appliance until the installation is complete.
Comments: Further description of the issues, who is responsible (Installer/ Builder/ Other Trades, etc) and corrective
action needed _____________________________________________________________________________________
_________________________________________________________________________________________________
_________________________________________________________________________________________________
Comments Communicated to party responsible ____________________ by ______________________on ___________
 = Contains updated information.
ATTENTION INSTALLER:
Follow this Standard Work Checklist
8000CLX-IFT
6000CLX-IFTLP 8000CLX-IFTLP
(Pg. 39)
(Builder / Gen. Contractor/) (Installer)
Heat & Glo • 6000CLX-IFT, 8000CLX-IFT Installation Manual • 2506-980 Rev. B • 3/18
Date Installed:
Location of Fireplace:
Installer:
Dealer/Distributor Phone #
Serial #:
YES IF NO, WHY?
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
___________________________
(Date)
2506-982 11/17
3