Recalling A Registered Setup - Casio CT-X5000 User Manual

Recalling a Registered Setup

To recall a setup
1.
As required, press cn FREEZE to toggle the
freeze function between on and off.
• The indicator lamp is lit when the function is on, and
unlit when it is off.
• For details about the freeze function, see "Freeze
Function" below.
2.
Use co BANK to select the bank that contains
the setup you want to recall.
3.
Press one of the cs REGISTRATION buttons
([1] to [8]) to select the area whose setup you
want to recall.
This causes the Digital Keyboard's settings to change in
accordance with the setup you recalled.
Bank number
Bank number
Area number
Registering and Restoring a Setup (Registration)
Freeze Function
Recalling a registered setup normally overwrites all of the
settings shown under "Registration Setting Items" (page
EN-68).
You can also use the freeze function to specify particular
settings that should not be overwritten when a setup
registration is recalled.
Perform the procedure under "To configure function settings
with the bk FUNCTION button" (page EN-112) and enable or
disable the items on each sub-menu that appears when you
perform the following operation: Registration Memory (Reg
Mem) 3 Registration Memory Freeze Target (RMFrzTgt)
(page EN-116).
Setting items that can be specified are shown below.
Setting that is not changed when a
Display
Rhythm Rhythm Number, ACCOMP on/off,
Synchro start/stop status
Tempo Tempo
Tone Tone number, Layer (on/off), Split (on/off),
Octave Shift, KEYBOARD part group mixer
settings
Split Pt Split Point, Lower Point, Chord Point,
Chord Input Priority Mode
AHar/Arp Auto Harmonize/Arpeggiator
Trans. Transpose
Scale Scales
Touch Touch Response
Effect Effect type (Reverb, Chorus, Delay on/off)
PartTune Coarse Tune, Fine Tune
Phr Pad Phrase Pad
Cntrller Setting items included under Controller
(Cntrller) in the "Function Setting Item List"
(page EN-113).
• Under initial default settings, Rhythm and Tempo are on
while all other settings are off.
setup is recalled
EN-69