Inputting Notes And Chords One-By-One (Step Input - Casio CT-X5000 User Manual

Using the MIDI Recorder to Record
To delete events in measure units
1.
Perform the procedure under "To enter the
Song Editing Mode" (page EN-99).
2.
Perform steps 2 and 3 under "To edit an event"
(page EN-106).
3.
Press cs REGISTRATION [8] (EDIT MENU).
4.
Use the [1] (V) and [3] (W) bm number keys
to display "Clear", and then press [6] (ENTER).
5.
Perform steps 5 through 7 under "To delete a
specified track in measure units" (page
EN-104).
To copy events in measure units
1.
Perform the procedure under "To enter the
Song Editing Mode" (page EN-99).
2.
Perform steps 2 and 3 under "To edit an event"
(page EN-106).
3.
Press cs REGISTRATION [8] (EDIT MENU).
4.
Use the [1] (V) and [3] (W) bm number keys
to display "Copy", and then press [6] (ENTER).
5.
Perform steps 5 through 8 under "To copy a
specified track in measure units and insert
them into a specified location of the same
track" (page EN-104).
EN-108
Inputting Notes and Chords One-
by-one (Step Input)
Step input is an event editor function. You can use step input
to specify the length and pitch of each individual note (note
event). In the system track, you also can perform step input of
Auto Accompaniment chords (chord events) as well.
• Performing step input into a track that already contains
recorded data will not delete the existing data. This means
you can use step input to add to existing recorded data.
• During step input, use the cs REGISTRATION buttons to
input notes, rests, etc.
To input note events using step input
1.
Perform the procedure under "To enter the
Song Editing Mode" (page EN-99).
2.
Perform steps 2 and 3 under "To edit an event"
(page EN-106), and confirm that the [EVENT]
indicator is displayed.
3.
Use the [2] (w) and [5] (q) bm number keys to
display the event within the measure from
which you want to start step input.
• The step input start point is the beginning of the
measure.
4.
Press cs REGISTRATION [1].
This displays the [STEP] indicator and enters the Step
Input Mode.
• During a step input operation, the current input point
(measure, beat, tick) is shown on the right side of the
display.
Measure
Displayed
Note Value
Beat
Tick