Configuring Phrase Recording Settings; Managing Phrase Sets - Casio CT-X5000 User Manual

Using Phrase Pads
Configuring Phrase Recording
Settings
If you change phrase recording settings, those settings will be
in effect for the subsequent recording operation as well.
Change the recording settings as required when recording a
new phrase.
To configure phrase recording settings
1.
Press bk FUNCTION.
2.
Use the [1] (V) and [3] (W) bm number keys
to display "Phr Pad", and then press [6]
(ENTER).
This displays "Phr Set".
3.
Press 8 RECORD/STOP.
This causes the [RECORD] indicator to flash.
4.
Long-press 8 RECORD/STOP until "Length"
is displayed.
• This enters the phrase recording setting mode.
5.
Use the [1] (V) and [3] (W) keys to select the
item whose setting you want to change.
• For information about setting items, see "Phrase
Recording Setting Items" (page EN-58).
6.
When all the settings are the way you want,
press 8 RECORD/STOP.
This causes the [RECORD] indicator to disappear.
EN-58
Phrase Recording Setting Items
Item Name
(Display)
Number of Specifies the length (number of
measures measures) of the phrase to be
(Length) recorded.
Quantize Specify either recording of notes
(Quantize) in the timing they are played on
the keyboard or automatic
alignment of notes based on a
note value. Selecting a setting
other than "Off" displays a note
value (4: quarter note, d: dotted
note, t: triplets).
Metronome Specifies whether or not the
(Metronom) metronome should sound during
recording.
Pre-count Specifies whether or not to
(Precount) sound a pre-count when
recording.

Managing Phrase Sets

You can use the procedures in this section to copy and delete
phrase sets.
To copy a phrase set
1.
Perform the procedure 1 through 3 under "To
change the phrase set" (page EN-54) to select
the number of the phrase set you want to copy.
2.
Long-press 8 RECORD/STOP until "Copy" is
displayed.
3.
Press the [6] (ENTER) bm number key.
This displays "Phr Set" and stands by for selection of the
copy destination.
4.
Use bn [–] and [+] or the bl dial to select the
copy destination phrase set number.
• Be sure to specify an empty area as the copy
destination.
5.
Press [6] (ENTER).
This displays "Sure?"
6.
Press bn [+] (YES) to execute or bn [–] (NO) to
cancel.
• Pressing bn [+] (YES) displays the message "Wait..."
(operation in progress). Do not perform any operation
while this message is displayed. "Complete" appears
after the operation is complete.
7.
To exit the operation, long-press the [4] (EXIT)
bm number key.
Description Settings
1 to 16
Off, 4, 8,
16, 32,
4d, 8d,
16d, 32d,
4t, 8t, 16t,
32t
On, Off
On, Off