Table of Contents
Advertisement
the value. The default is "ON".
Push the OK button to set the Telemetry Heart Rate Receiver to active.
11. The Console will go to the Power-Up Mode screen with the user selected.
Reset a User Profile
1. From the Power-Up Mode screen, push the User button to select one of the User Profi les.
2. Push the OK button to select the User Profile.
3. The Console display shows the GOAL TRACK prompt. Push the Decrease () button to change the prompt.
Note: To exit the User Profile options, push the PAUSE/STOP button and the console will go back to the Power-Up
Mode screen.
4. The Console display shows the RESET prompt and the current User Profile name. Push OK to start the Reset User
Profi le option.
5. The Console will now confirm the request to reset the User profile (the default selection is 'RESET - NO'). Push the
Increase() or Decrease() buttons to adjust the selection.
6. Push OK to make your selection.
7.
The Console will go to the Power-Up Mode screen.
Changing Incline Levels
Push the Incline Level Increase() or Decrease() buttons to change the incline angle of the Deck at any time with the
Safety Key installed. To rapidly change the incline level push the desired Pre-Set Incline Button, and then the Incline Enter
Button. The Deck will adjust to the selected incline level.
Note: After a Pre-Set Incline Button is pushed, the Incline Enter
Button must be pushed within 12 seconds.
Be sure the area below the machine is clear before
lowering the Deck. Fully lower the Deck after each
workout.
Exercise on this machine requires coordination and
balance. Be sure to anticipate that changes in belt
speed and incline angle of deck can occur during
workouts, and be attentive in order to avoid loss of
balance and possible injury.
Be sure that the workout space you are utilizing has adequate
height clearance, taking into consideration the height of the user
and the maximum height of the fully inclined Deck.
Changing Speed Levels
Push the Speed Level Increase() or Decrease() buttons to
change the Belt Speed at any time in a workout program. To
rapidly change the Speed level push the desired Pre-Set Speed Button, and then the Speed Enter Button. The Walking
Belt will adjust to the desired speed.
Note: After a Pre-Set Speed Button is pushed, the Speed Enter Button must be pushed within 12 seconds.
Pre-Set Incline
Buttons
Incline Enter Button
37
Hide quick links:
Advertisement
Table of Contents
