Table of Contents
Advertisement
0
2
4
6
8
P40 Gas Fireplace
Venting Arrangements - Horizontal
Terminations
Two 45° elbows = One 90° elbow
This diagram shows all allowable combinations of vertical runs with
horizontal terminations, using one 90° elbow
The unshaded area in the diagram shows allowable venting
confi gurations with the Vent Restrictor Factory Set.
The lightly shaded area,
confi gurations with the Vent Restrictor on Set 1.
The darker shaded area,
confi gurations with the Vent Restrictor on Set 2.
14
12
10
8
6
4
2
0
50
10
12
14
16
18
, in the diagram shows allowable venting
, in the diagram shows allowable venting
0
2
4
Vent Restrictor
on Set 2
Vent Restrictor
on Set 1
45-3/8"
(1143mm)
Minimum
Height
Requirement
20
22
24
26
Gas Fireplaces
Note: Must use optional rigid pipe adapter (Part # 770-994) when
using Rigid Pipe.
•
Maintain clearances to combustibles.
•
Horizontal vent must be supported every 3 feet.
•
Minimum of 1' pipe section between any elbows.
•
Firestops are required at each fl oor level and whenever passing
through a wall.
A vent guard may be required as per local codes, refer to page 11 for
"Exterior Vent Termination Locations".
Note: FPI Direct Vent System (Flex) is only approved for horizontal
terminations.
Horizontal (Feet)
6
8
10
12
Vent Restrictor
Factory Set
Please refer to Page 11 (Exterior Vent Terminations)
for additional guidelines on vent locations.
June 2007 Regency Product Specifi cations Book
28
30
14
16
18
20
Advertisement
Table of Contents
