Commissioning; Installing The Outer Fascia Panel; Installing The Inner Fascia Panel - Rinnai RHFE-952ER Operation & Installation Manual

HEATER INSTALLATION
6.

COMMISSIONING

Extended Flue
The gas pressures of the appliance are factory pre set for 'extended
flue' installations (page 21 Options
normally not require adjustment and you may proceed to step 7).
Direct Flue
If the appliance is to be used with a 'direct' flue system (page 21
Option ), then gas pressures will need to be adjusted in
I
accordance with the commissioning instruction sheet
a plastic pouch inside the appliance at the bottom right.
When commissioning is complete check for full and correct
operation of the appliance, and return the commissioning instruction
sheet to its plastic pouch, proceed to step 7.
7.

INSTALLING THE OUTER FASCIA PANEL

1. Remove but DO NOT DISCARD the two fascia retaining screws
mounting brackets
O
a
P
2. Position the fascia close to the heater engine and connect the RJ45 plug into the socket located on the inside
top left of the fascia
engine's control box).
3. Mount the outer fascia
the top lip of the engine body
wall surface . Secure the fascia to the heater engine with two retaining screws
c
8.

INSTALLING THE INNER FASCIA PANEL

1. Mount the inner fascia
lip of the combustion chamber frame
c
2. Rotate the bottom of the inner fascia
inner fascia to the heater engine.
Rinnai
, ,
II III IV
of the heater engine.
N
b
M/N
, (this connects the push button control panel via a communications cable to the heater
O
to the engine by hooking the top inside fold of the outer fascia
P
, then push the outer fascia in towards the engine body until flush with the
b
to the engine by hooking the tabs of the inside top of the inner fascia
Q
.
b
a
d
Q
in towards the engine body allowing the magnets
c
and ) and will
V
located in
L
b
c
a
P
b
Q
28
shipped installed in the lower fascia
M
P
M
a
.
M
J
over the tabs on
to the top
a
to secure the
d
RHFE 952_1252 OIM