Drive Chain Adjustment - HYOSUNG RX125 Owner's Manual

① The clutch lever play.
② The lock nut
③ The clutch lever adjuster
④ The rubber boot
⑤ The cable adjuster
⑥ The clutch cable adjuster lock nut.
If you find the play of the clutch incorrect,
adjust it in the following way :
� CLUTCH CABLE
(1) Loosen the lock nut ② and the clutch
lever adjuster ③ turn all the way toward
clockwise.
(2) Loosen the clutch cable adjuster lock nut
⑥.
Turn the cable adjuster ⑤ that the clutch
lever
play ① should be 4mm(0.16in)
(3) A little adjustment be allowed by the
clutch lever adjuster ③.
(4) After end of adjustment, tighten the lock
nut ②, ⑥ and cover the rubber boot ④.

DRIVE CHAIN ADJUSTMENT

The chain may require more frequent
adjustment that it is with periodic mainte
nance depending upon your riding condi-
tions.
Check the chain every 1,000km.
Chain adjust in the following way.
4
1
(1)Place the motorcycle on the jack or
block
(2) Loosen the axle nut ①.
(3) Adjust the slack in the drive chain by
adjuster ③ as the lock nut ② turning
toward the left and right.
(4) For alignment of the rear sprocket and the
front sprocket, there are reference mark ④
on the same position.
After aligning and adjusting the slack in
the drive chain to 50~60mm (2.0~2.4in),
retighten the axle nut securely and perform
a final inspection.
The drive chain for this motorcycle is
made of the special material.
The chain should replaced with either a
428H.
Use of another chain may lead to prema-
ture chain failure.
The drive chain should be inspected
every time before riding.
Excessive chain slack could cause the
3
chain to come off the sprockets and
result in accident or serious engine dam-
2
age.
20
▲CAUTION
!
▲CAUTION
!