Carburetor - HYOSUNG RX125 Owner's Manual

(2) Remove the engine oil filter plug ①.
(3) Drain the oil by removing the drain plug
② located on the bottom of the engine.
5
4
6
▲CAUTION
!
Insert the filter so that surface of the
filter hole turn toward the engine.
2
3
7
18
(4) Remove the three nuts.
Remove the filter cap ⑥, pull out the
element and replace with a new oil filter
element.
(5) Before replacing the oil filter cap ⑥,
check to be sure that the filter spring ④
and cap "O" ring ⑤ are installed correctly.
Install a new "O"ring each time that the
filter element is replaced.
(6) Replace the oil filter cap and tighten the
bolts securely.
(7) R e p l a c e t h e d r a i n p l u g a n d p o u r
ml
about 950
hole.
(8) Operate the engine a few second by
idling speed.
Inspect to leak oil at the oil filter
cap.
(9) Confirm the oil level through the oil level
lenz after waiting about a minute next to
stoping the engine.
The oil level is located between the "Lower
line" and the "Upper line" .
When below the "Lower line" , refill the oil
between the "Lower line"and the "Upper
line" .
▲CAUTION
!
When remove the drain plug, pay attention
extremely to lose the spring and the shifting
cam stopper.

CARBURETOR

Undisturbed carburetion is the basis of
the performance you ought to expect of
your engine.
The carburetor is factory-set for the
best car buretion.
Do not attempt to alter its setting.
T h e r e a r e t w o i t e m s o f a d j u s t m e n t ,
however, under your care : engine idle
speed and throttle cable play.
of oil through the plug