Printing Area - Custom Audio Electronics TG2480H User Manual

10.3 Printing area

In order to print ticket containing only one notch and to not overlay printing to a notch (that will make it useless for the next
alignment), it is important to well calibrate the length of the printing area of ticket according to the inter-notch distance.
The following igure shows an example of tickets with "Notch Distance" set to 0:
Cutting Printing
line
A
A "Non-printable area" = "Distance between cutter/printing head"
where:
"Distance between cutter/printing head" = 12 mm
H Distance between the irst and the last print line, called "Height of the printing area".
L Distance between an edge of the notch and the next one, called "Inter-notch distance".
D Automatic feed for alignment at the next notch.
To use all the notches on the paper, you must comply with the following equation:
H + A ≤ L
The height of the printing area H can be increased to make no progress on alignment D but no further.
90
line
PRINTING
L
PRINTING DIRECTION
AREA
H
Cutting Printing
line line
D A