Related Manuals for Horizon Fitness Andes 2
Summary of Contents for Horizon Fitness Andes 2
- Page 1 FOR MODEL: Andes 2 Andes 3 Rev. 1.0 | 020909’ 02/09/09 3:31:08 PM...
-
Page 2: Tools Included
A SSE MB LY CONSOLE UPPER HANDLEBAR HANDLE PULSE CONSOLE MAST BOOT IMPORTANT: READ THESE SAFETY INSTRUCTIONS BEFORE USE! BOTTLE HOLDER HANDLEBAR COVERS CONSOLE MAST WARNING CONSOLE MAST BOOT LOWER HANDLEBAR There are several areas during the assembly process of an elliptical that special attention must be paid. HANDLEBAR COVER It is very important to follow the assembly instructions correctly and to make sure all parts are firmly PEDAL... -
Page 3: Assembly Step
ASSEMBLY STEP 1 ASSEMBLY STEP 3 HARDWARE BAG FOR STEP 3 CONTENTS : A) Open HARDWARE BAG FOR STEP 1. B) Attach the washer (A) to the tube (D),and then attach CONSOLE WIRE BOLT (B) SPRING WASHER (C) the transport wheel to the stabilizer tube (E) using 8.2x 13.5x2.0t M8x1.25Px15L washer(B), screw(C). - Page 4 A) Open the hardware bag for the step 4. ASS EM BLY S TEP 6 B) Place the pedal arm onto the pivot- tube using 2 TEFLON WASHERS(A) A) Open the hardware bag for the step 6. AND 1 NYLON NUT(B). B) Attach the linkage arm onto the pedal arm C) Remove 2 pre-attached screws (C) pin using (A),(B),(C),(D) one by one.
- Page 5 A S S EMB LY ST EP 7 NOTE:There is NO hardware bag for this step. All hardware is pre-installed. A) Attach the CONSOLE WIRES. B) Carefully tuck the CONSOLE MAST wires into the CONSOLE console MAST before attaching the CON- SOLE.