SATO MB200i Operator's Manual page 28

Setup
Installing the label roll (cont'd)
For operating in the Dispense mode, the
following media loading procedures apply.
1. Ensure the red platen roller
can be seen. If not, slide the
dispenser unit to its home
position, by lifting upward
on its top edge at the two
arrow marks. Then press
the dark gray Cover Open/
Close lever toward the front
panel for its release.
2. Peel the first label from the
roll.
This step is unnecessary
when a linerless label is
used.
2-14
Dispenser
unit