General Maintenance - Agilent Technologies 5975T LTM GC/MSD Troubleshooting And Maintenance Manual

Agilent 5975T LTM GC/MSD
Troubleshooting and Maintenance Guide
10

General Maintenance

Before Starting 110
To Attach a Capillary Column Using SilTite Metal Fittings
To Disconnect Fused Silica Tubing From a SilTite Fitting
Maintaining the Vacuum System
To Check and Add Foreline Pump Oil
To Drain the Foreline Pump
To Refill the Foreline Pump
To Maintain the Dry Vacuum Pump
To Refill the EI Calibration Vial
To Purge the Calibration Valves
To Remove the EI Calibration and Vent Valve Assembly
To Reinstall the EI Calibration and Vent Valve Assembly
To Install a Micro-Ion Vacuum Gauge
To Remove the Micro-Ion Vacuum Gauge
To Lubricate the Side Plate O-Ring
To Lubricate the Vent Valve O-Ring
Maintaining the Analyzer
To Remove the EI Ion Source
To Disassemble the EI Ion Source
To Clean the EI Ion Source
To Reassemble the EI Ion Source
To Reinstall the EI Ion Source
To Remove a Filament 149
To Reinstall a Filament 151
To Remove the Heater and Sensor from the Ion Source
To Reinstall the Heater and Sensor in the Ion Source
To Remove the Heater and Sensor from the Mass Filter
To Reinstall the Heater and Sensor in the Mass Filter
To Replace the Electron Multiplier Horn
Maintaining the Electronics
To Adjust the Quad Frequency
To Replace the Primary Fuses
Agilent Technologies
118
119
121
122
123
125
127
130
132
133
135
137
139
141
143
146
148
158
160
162
164
114
117
128
129
152
154
155
156
109