HP ProLiant ML110 G6 Maintenance And Service Manual page 42

Remove four screws from the sides of the drive.
d.
Reuse these screws when you install the new hard drive.
Place the old hard drive on a static-dissipating work surface or inside an anti-static bag.
e.
Remove the new hard drive from its protective packaging.
5.
Do one of the following:
6.
○
If you intend to replace an old hard drive, insert the four screws you removed in step 4-d into
the new drive.
○
If you intend to install an additional hard drive, remove four spare HDD screws from the front
chassis, and then insert them into the new drive.
Install the new SATA hard drive.
7.
Slide the new hard drive into the selected bay until it clicks into place (1).
a.
Connect the power and data cables to the back of the hard drive (2).
b.
Removal and replacement procedures 42