HP ProLiant ML110 G6 Maintenance And Service Manual page 39

Remove the new media drive from its protective packaging.
5.
Do one of the following:
6.
○
If you intend to replace an old media drive, insert the four screws you removed in step 3-d
into the top screw holes on the sides of the new media drive.
○
If you intend to install an additional media drive, remove four spare removable media drive
screws from the front chassis, and then insert them into the top screw holes on the sides of the
new media drive.
Install the new media drive.
7.
Slide the new media drive into the selected bay until it clicks into place (1).
a.
Connect the data and power cables to the back of the media drive (2).
b.
Perform the post-installation procedure.
8.
Removal and replacement procedures 39