Table of Contents
Advertisement
4
Position steel balls on hole and drive in to
specified stop on punch.
5
After reassembling engine, warm up engine
and check for leakage in area of steel balls.
Note
If one of the steel balls does not seal sufficiently
after inserting or if leakage is present following
leakage test, replace steel ball with plug.
Replacing steel ball with plug
6
Knock steel ball out again.
7
Cut thread in hole for leaky ball.
Note
Front bore M 18 X 1.5
Rear bore M 16 X 1.5
8
Thoroughly clean oil duct, screw in front plug
with gasket and rear plug with sealant
002 989 94 71, tightening torque 50 Nm.
01.10 - 13013
10 m m deep
14 mm deep
EXIT
Hide quick links:
Advertisement
Table of Contents
