Mercedes-Benz 603 Service Manual page 39

Model 201 (up to 03185):
Engine shock absorber
Model 126:
Engine shock absorbers (24), left and right . . . . .
Manual transmissions:
Shift linkage (20)
Clutch master cylinder (18)
Automatic transmissions:
Shift linkage (20)
Starter lockout, back-up light switch (S16/1)
Speedometer shaft (19) or inductive
speedometer sensor (L2)
Engine speed sensor (L3) and starter
ground strap
Lateral exhaust support (23)
Heat baffle plates (22)
Drive shaft (492)
Drive shaft intermediate bearing (495)
Clamping nut (500)
01.10 - 030/4
remove, install, 10 Nm (item 27).
remove, install, 10 Nm (item 28).
unhook, hook in (item 29).
remove hydraulic line, replace and bleed master
cylinder (item 29.1).
unhook, hook in (30).
disconnect wires, reconnect (item 30).
disconnect wire, reconnect (item 30.1).
remove, reinstall (item 31).
remove, reinstall (item 32).
remove, reinstall (item 33).
on center tunnel, remove, install (item 34).
remove, reinstall, 40 Nm and 60 Nm
(item 35).
Note
Replace self-locking hex. nuts.
loosen, tighten, 25 Nm (item 36).
on intermediate bearing, loosen, tighten,
30 - 40 Nm, open-end wrench
126 589 00 01 00 or 201 589 00 01 00 and
torque wrench 001 589 66 21 00 (item 37).
EXIT