Engineering Level Parameters - Omron E5AJ-A2HB Operation Manual

Engineering Level Parameters

9-3 Engineering Level Parameters
58
The value set before shipping
appears. (see note 1)
( C/ F selection)
Displayed if the E5jJ with a com-
munications function is used.
(Data bit length setting)
(Parity check setting)
(Stop bit length setting)
Displayed if the E5jJ is in advanced
PID operation with fuzzy self-tuning.
15.0
(Stable range setting)
Displayed if the E5jJ is in advanced
PID operation.
(Alpha setting)
(Automatic return of display mode)
Displayed if the E5jJ with an alarm
function is used (see note 2).
(Standby sequence
reset method setting)
(Input shift display selection)
Displayed if the E5jJ with an alarm
function is used (see note 2).
(Alarm 1 hysteresis
setting)
Displayed if the E5jJ with an alarm
function is used (see note 2).
(Alarm 2 hysteresis
setting)
(Set point lower limit setting)
(Set point upper limit setting)
Displayed if the E5jJ with
event input 2 is used.
(Event input 2 function
selection)
Note: 1. The E5jJ-jjjj-F values set before shipping may be
different. Refer to 9-2 Engineering Level Parameter List.
2. The value will not be displayed if the alarm mode switch is
set to 0 or if the E5jJ does not incorporate any alarm.
Section 9-3