Hydraulic System; Fluid Level - Blizzard SPEEDWING 8600SW Owner's Manual

HYDRAULIC SYSTEM

Fluid Level

CAUTION
Do not mix different kinds of hydraulic fl uid.
Some fl uids are not compatible and may cause
performance problems and product damage.
NOTE: Remove the breather slowly to relieve any
pressure in the reservoir.
1. With the snowplow attached to the vehicle and the
blade on the ground, turn the control OFF.
Arm/Blade Operation
Switch
Power
Switch
Switch
Label
2. Move the Power switch to the center, or "OFF,"
position.
3. While holding the Power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch.
The arm will disengage the mount adapter and
fully retract the lift ram.
Lit. No. 40688, Rev. 04
MAINTENANCE
4. Remove the breather. Fill the reservoir to 1" from
the top and replace the breather.
5. Turn the control ON. Raise and lower the blade to
reposition the draw latch.
Light
For fl uid recommendations, see the following Annual
Tower
Fluid Change section.
33
Breather
Drain Plug
Reservoir
May 1, 2012