Hydraulic Rotation With Cylinder - 8056 (Optional) - Blizzard B54 Operator And Parts Manual

Hydraulic Rotation with Cylinder 8056 (Optional) Figure 6
1. Place the plastic anti-friction insert (fig.2, item
4) over the chute base, placing the raised part
upside and toward the center of the frame.
2. Install the adjustment tube (fig. 2, item 3) in
the lower hole on the backside of the chute
and the adjustment rod (fig. 2, item 2) in the
upper hole. Lock in place using the 1/4" x 2"
(fig. 2, item 7) cotter pins then insert the
∅5mm x 100mm hair pin (fig. 2, item 6) in the
adjustment tube hole (fig. 2, item 3)
3. Install the chute (fig.2, item 1) over the plastic
insert (fig.2, item 4), applying grease in
between, and place the four retaining plates
(fig.2, item 5). Secure using eight 1/4'' x 3/4''
bolts, lockwashers and nuts (fig.2, items 8-9-
10). Tighten all bolts securely.
4. Install the cylinder bracket (Fig. 6, item 1)
through the ∅13/32" hole on the frame by
inserting a 3/8" NC x 1" bolt (item 13), then
tighten with a flat washer (∅7/16" hole), a
lockwasher and a nut (items 6-7-8).
Figure 6
OM 0279-A
ASSEMBLY
5. Install the bell crank (item 2) on the frame by
sliding a spacer (item 4) under the cylinder
bracket, opposite the ∅11/16"hole. Insert a
bushing (item 5) in the ∅1 1/8" hole of the bell
crank and slide the bell crank between the flat
bars of the cylinder bracket.
everything by inserting a 5/8" NC x 3 3/4" bolt
(item 12), a lockwasher and a nut (items 16-
17).
6. Install the push arm (item 3) by sliding it
between the bell crank plates, greasing
generously.
7. Insert a 3/8'' x 3/4''NC shoulder screw (item
14) under the part and tighten with a ∅3/8"
hole flat washer (item 10) and a 5/16''NC
stover.nut (item 9), leaving some movement
to the push arm.
8. Slide the other push arm end between the flat
bars welded on the chute base. Inserting a
∅7/16" hole nylon flat washer (item 15) under
the push arm. Fasten everything with a 3/8" x
1" shoulder screw (item 11), a ∅3/8" hole
flatwasher (item 10) and a 5/16''NC stover.nut
(item 9), leaving some movement to the
mechanism.
9. This system works with a 8'' hydraulic cylinder
extension and a 20 1/4'' centre-to-centre pin
retracted.
13
Fasten