Removing Snowplow From Vehicle & Storage - Blizzard SPEEDWING 8600SW Owner's Manual

REMOVING SNOWPLOW FROM VEHICLE & STORAGE
REMOVING SNOWPLOW (OFF)
WARNING
Keep 8' clear of the blade when it is being
raised, lowered or angled. Do not stand
between the vehicle and blade or directly in
front of the blade. If the blade hits or drops on
you, you could be seriously injured.
WARNING
Inspect snowplow components and fasteners
for wear or damage whenever mounting or
removing the snowplow. Worn or damaged
components could allow the snowplow to
drop unexpectedly.
During the off-season, the control can be removed.
Disconnect the connector in the cab and store the
control in the glove box of the vehicle.
1. Lower the snowplow onto the ground with the
blade straight. Turn the plow control in the
cab OFF.
Lit. No. 40688, Rev. 04
2. Move the Power switch to the center, or "OFF,"
position.
Arm/Blade Operation
Switch
Power
Switch
Switch
Label
3. While holding the Power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch.
The arm will disengage the mount adapter to
relieve tension on the stand.
4. Pull the stand pin out. Rotate the stand down until
the stand pin seats into the lower A-frame hole.
The stand pin must lock into the lower A-frame
hole. Push down on the top of the shoe. The shoe
will be on the ground.
Light Tower
Blade
Boot
Power Switch
Upper Hole
Stand Handle
28
Light
Tower
Arm/Blade
Operation Switch
Hitch Pin
A-Frame
Raise
OFF
Lower
POWER ARM/BLADE
48207 OPERATION
Arm
Stand Pin
Mount
Stand
Adapter
Shoe
OFF
May 1, 2012