Table of Contents
Advertisement
REMOVING SNOWPLOW FROM VEHICLE & STORAGE
5. Repeat Step 4 on the passenger's side.
6. Push and hold the Power switch RIGHT and push
UP the Arm/Blade Operation switch. The arm will
engage the mount adapter and pull the snowplow
tightly to the vehicle.
7.
Rotate and pull the hitch pin. Rotate the hitch pin
into the retracted position.
Hitch
Pin
8. Repeat Step 7 on the passenger's side.
9. While holding the Power switch RIGHT, push
DOWN and hold the Arm/Blade Operation switch
to fully lower the arm.
Lit. No. 40688, Rev. 04
Mount
Adapter
Pin
Guide Plate
Pin
Handle
29
10. Unplug the electrical harnesses.
NOTE: After each use of the snowplow, reapply
dielectric grease to the electrical plugs to
maintain the protective coating on the terminals.
CAUTION
On 2-plug electrical systems, plug covers
shall be used whenever the snowplow is
disconnected. Vehicle Battery Cable is 12-volt
unfused source.
11. Place the electrical plugs in storage position. The
plugs are equipped with plug covers.
May 1, 2012
Hide quick links:
Advertisement
Table of Contents
