Installation Of Hydraulic Rotation Kit Ber0077 - Blizzard B74C Operator And Parts Manual

Installation of Hydraulic Rotation Kit BER0078
(Figures 8 to 12)
1. Install the chute according to the instructions
contained in the snowblower Operator's
Manual.
2. Figure 10: Place the motor spacer (item 2) on
the motor top (item 1) by aligning the holes.
Install the motor (item 1) under the frame
base of the snowblower and secure with four
3/8''NC x 1'' bolts (item 3), four 3/8"
lockwashers (item 4) and four 3/8" (7/16"
hole) flat washers (item 5). Torque slightly.
3. Figure 10: Make sure the Woodruf key is on
the motor shaft and insert the motor gear
(item 6) on the shaft. Secure with a 1/4''NC x
1'' bolt (item 7), a 1/4" lockwasher (item 8)
and a 1/4" (5/16" hole) flat washer (item 9).
4. Figure 11: NOT INCLUDED: Using thread
sealant, install a 1/4"NPT female x 1/2"NPT
male reducer (item 2), a male quick coupler
(item 3) and a dust cap (item 4) on each
straight end of the hoses (item 1).
CAUTION
To avoid serious personal injury.
hydraulic/ diesel fluid under pressure can
penetrate the skin causing serious injury.
•
Do not use your hands to
check for leaks. Use a
piece of cardboard or
paper to search for leaks.
1. Hydraulic hose
2. Cardboard
3. Magnifying glass
• Stop engine and relieve pressure before
connecting or disconnecting lines.
• Tighten all connections before starting
engine or pressurizing lines.
• If any fluid is injected into the skin, obtain
medical attention immediately or gangrene
may result.
OM 0410SB-A
ASSEMBLY
Figure 8
Escaping
Figure 9
18