Hydraulic System; System Capacity; Pump Motor Specifi Cations; Cab Controls - Blizzard 7600LT Owner's Manual

HYDRAULIC SYSTEM

The hydraulic unit delivers fast and uniform speed
for lifting and angling. Straight blades are raised in
approximately 2 seconds and angled side to side in
approximately 2 seconds.
For hydraulic fl uid type and fi lling instructions, see
Hydraulic System, Annual Fluid Change, in the
Maintenance section of this Owner's Manual.
Speed Adjustment
Breather
Drain Plug

System Capacity

• Unit Reservoir ............................ 1-3/4 quarts
• System Total .................2-3/8 to 2-3/4 quarts
Pump Motor Specifi cations
12V DC with +/– connection
1850–1950 psi pump relief valve
3950–4050 psi angling relief valve
4.5" dia 1.5 kW motor
0.000477 gal/rev Pump
Hydraulic hose SAE 100R1
Lit. No. 40595, Rev. 05
GETTING TO KNOW YOUR SNOWPLOW
Blade Drop
Motor
Valve
Manifold
Reservoir

CAB CONTROLS

To prevent accidental movement of the blade,
always turn the control OFF whenever the
snowplow is not in use. The power indicator
light will turn OFF.
BLIZZARD snowplows come equipped with one of
®
two special controls: the POWER GRIP™ hand-held
control or a joystick-style control.
Each control has its own ON/OFF switch with an
indicator light to show when the control is powered
up. Your vehicle ignition (key) switch controls a fused
circuit that powers your cab control directly from the
battery.
The ON/OFF switch on the cab control allows you to
turn OFF the control and prevent blade movement
even when the ignition switch is ON.
The control ON/OFF switch serves as an
emergency stop if required.
All controls are protected by a replaceable fuse
located in the under hood snowplow electrical system.
See Fuse Replacement in the Maintenance section of
this Owner's Manual.
POWER GRIP
Hand-Held Control
(emergency stop)
ON/OFF Switch
(emergency stop)
13
WARNING
ON/OFF Button
Power Indicator
Light (red)
Joystick Control
May 1, 2021