Certified Quality; Rating Plate - Spartherm Magic Operating Manual

1. CERTIFIED QUALITY

OUR FIREPLACE INSERTS HAVE BEEN TESTED WITH CE APPROVAL
PURSUANT TO EN 13229. THE DECLARATION OF PERFORMANCE IS
AVAILABLE AT WWW.SPARTHERM.COM
A = not a self-closing door
• open operation possible under certain conditions
• does not allow multiple connection of the flue
We recommend operating Type A units with a closed firebox door, as well. As
a result, the use of wood energy will improve and the operational reliability
will increase. In particular, soot or odours can easily enter the room through
an open firebox door, due either to air movements or to weak or uneven
chimney draughts.
A1 = Self-closing door
• Closed operating mode
• Multiple connection of the flue possible
Except when feeding, the firebox on Model A1 should always be kept locked
to prevent the escape of hot gases. The locking mechanism on Model A1
must not be tampered with. Interference with the mechanism renders both
the warranty and operating licence invalid. The guarantee and operating
licence are also rendered invalid if the customer has modified the technol-
ogy of any other area of the fireplace insert. The desired design should have
been clarified with you by your retailer before ordering.
These operating instructions comply with the provisions outlined in DIN EN
18896 „Solid-fuel fireplaces".
National and regional regulations, construction methods or materials may vary
from this exemplary version, but are to be observed. Our fireplace inserts are
designed for short term burning and are not intended for use under continuous
combustion conditions.
Of course, our fireplace inserts are subject to the company's own quality
criteria of the incoming goods inspection up to final acceptance prior to
shipment.

2. RATING PLATE

For the Magic fireplace insert, the rating plate is located in the internal
recessed inspection door below the firebox door. To reach the inspection
door, the firebox first has to be rotated (see „4.2.1 Starting a fire for begin-
ners"). To open the inspection door, unscrew the recessed Allen screws. The
rating plate is attached to the underside of the inspection door.
To open the inspection door, unscrew the recessed Allen screws. (Fig. 1).
Turn the disengaged inspection door around (Fig. 2) .The rating plate is
located on the bottom (Fig. 3).
GB 4
Fig. 2
Fig.1
Fig. 3