Verifying Successful Installation; Verifying The Connection To The Printer - HP bt1300 User Manual

Verifying Successful Installation

After the hp bt1300 is attached to the printer and powered ON, it will perform a brief startup sequence:
1. The bi-colored LED (amber) and the blue LED will blink three times simultaneously.
2. The bi-colored LED will alternately blink amber and green twice. The blue LED will not light.
3. The bi-colored LED will illuminate green continuously, and the blue LED will blink continuously,
indicating a ready state. After Bluetooth connectivity has been established, the blue LED will
illuminate continuously.
NOTE: If the bi-colored LED does not illuminate green continuously after the device has finished its startup
sequence, then there may be an error. Refer to Chapter 5 – Troubleshooting in this user's guide for help.

Verifying the Connection to the Printer

To verify the connection, make sure that both the hp bt1300 and the printer are powered on and ready.
Then print a test page by momentarily pressing the test button
second. If the test page prints successfully, then the hp bt1300 is ready to print, providing that the
client computer and sending device are ready to print.
If the test page does not print, check to make
sure that the hp bt1300 is securely connected to
the printer. Also, ensure the printer is operating
properly and has a sufficient supply of paper
and toner or ink. Switch the hp bt1300 off and
then on again, and then try printing the self-test
page again by pressing the test button
about one second. If you cannot print a test
page, refer to Chapter 5 – Troubleshooting in
this user's guide.
HP Printer Adapter User's Guide
for
on the hp bt1300 for about one
Test Button
2- 3