How To Use Modeling Lamp Power Control - Sekonic LITEMASTER PRO L-478DR-A-EL Operating Manual

2-2-3. How to use Modeling Lamp Power Control

1) Press the Modeling Lamp icon (
Flash Power Control screen.
2) Select one of Groups (G1 to G4)
Lamp ON/OFF icon (
Group.
3) Press the Measuring button to measure the brightness of
the light(s) in the selected Group.
4) The measured value is displayed at the top of the screen
and over the selected Group button
1
button to change the power of modeling lamp. Set power
4
level is displayed in the area of
* Up to +/-9.9 step of value (f stop) can be controlled.
* Set power level returns to 0 (zero) when taking a measurement, selecting
another Group or turning power off/on.
5) Press the Measuring button again to check that the
modeling lamp power is set to desired value.
6) Repeat 2) to 5) above for other Groups to check that each
flash unit's modeling lamp brightness is set to proper value
for the effect you want.
7) Select [ALL] button and press the Measuring button.
Measured values of each Group
lighting ratio data. The measured F number
total exposure for all lights.
8) Press [+] or [-] button
modeling lamps while maintaining the established ratio.
* Press Modeling Lamp ON/OFF icon (
desired Group.
* To set ISO sensitivity and shutter speed, press the Radio Flash Mode
icon ( ) to go back to the Measuring screen.
* To go back to Flash Power Control screen, touch the Flash Power
Control icon ( )
•
M odeling Lamp Power Control mode is ambient light
measurement.
) at the bottom right of the
and press the Modeling
3
) to turn ON the lamp of the selected
2
.
5
are fixed to keep the
2
to change the total power of
4
) if necessary after selecting the
8
. Press [+] or [-]
indicates the
1
Flash Power Control
screen
Modeling Lamp Power
Control screen
1
2
3
4
Settings
(EL-Skyport mode, FCH,
shutter speed and ISO
sensitivity)
Modeling Lamp Power
Control screen
5