Garmin G5 Installation Manual page 119

8.4.10 Backlight Configuration Page
Configuration
Setting
Current Mode
Default Mode
Minimum Photocell
Input
Minimum Display
Brightness
Maximum Photocell
Input
Maximum Display
Brightness
Filter Time
Constant
Photocell Input
Display/Manual
Brightness
190-02072-01
Rev. 2
Figure 8-34 Backlight Configuration Page
Table 8-12 Backlight Configuration Settings
Used to set the backlight mode to automatic or manual. This setting is also
available at any time by pressing the power button.
Automatic mode sets the backlight intensity (display brightness) based on the
photocell (ambient light sensor) input on the G5. Manual mode allows for setting
the backlight intensity by changing the Backlight percentage directly. Manual
brightness control is available at any time by pressing the power button.
Used to set the backlight mode that will be active each time the unit is powered
on.
Sets the photocell reading that will result in the minimum display brightness in
automatic mode. The default is 10%.
Sets the minimum display brightness setting that will occur in automatic mode.
The default value is 20%.
Sets the photocell reading that will result in the maximum display brightness in
automatic mode. The default is 70%.
Sets the maximum display brightness setting that will occur in automatic mode.
The default value is 100%.
Adjusts the speed (in seconds) that the brightness level responds to changes in
the photocell input.
Displays the current input on the unit's light sensor (0%-100%).
Displays the current backlight level (0%-100%). Naming convention depends on
the current backlight mode selected.
Description
G5 Installation Manual
Page 8-53