Basic Operation; Idle Mode - Henny Penny EVOLUTION ELITE EEG-241 Operator's Manual

3-5.

BASIC OPERATION

3-6.

IDLE MODE

March 2014
The Evolution Elite fryer is available as non-auto-lift and auto-lift
models. The auto-lift controls, allow the baskets to be automatically
lowered into the shortening at the beginning of the cook cycle, and raised
from the shortening at the end of the cycle.
Once out of the Melt Cycle, LOW TEMP flashes until the setpoint
1.
temperature has been reached. Once the setpoint temperature has
been reached, the product name now shows in the display, ex: FRY,
and product now can be placed in the oil.
Press a timer button
2.
Display shows the name of the product cooking (ex: "FRY") and the
3.
timer counting down.
When cook cycle is complete, an alarm sounds and display shows
4.
"DONE".
Press the timer button under "DONE" to stop the alarm, and lift
5.
basket from vat.
If a Quality Timer (hold timer) has been programmed, the hold time
6.
starts automatically when the user presses the timer button to end the
cook cycle. While the quality timer counts down, the display shows
the three-digit product abbreviation followed by "Qn",where "n" is
the number of minutes remaining. ex: "FRY" / "Q5" / "FRY" / "Q5"
/ "FRY" / "Q4", etc.
At the end of the timer countdown, control beeps and the display shows
"QUAL" followed by the three-digit product name: "QUAL" / "FRY" /
"QUAL"/ "FRY". Press the timer button to cancel the timer.
To stop a cook cycle at any time, press and hold the timer
Once programmed, Idle Mode help saves on oil and utility costs by
lowering set-point of oil when vat is not being used. To activate Idle
Mode, press button, or can be programmed to activate automatically
after "X" minutes of inactivity on the vat.
The oil is maintained at a lower temperature until the
pressed, and then the oil is heated to cooking temperature. See Special
Program Modes SP-7, SP-7A, SP-7B, & SP-7C.
22
or .
button or .
button is