Features & Benefits - Rinnai REU-AM2626WDL Operation & Installation Manual

FEATURES & BENEFITS
Congratulations on purchasing the latest technology temperature controlled Rinnai continuous flow water heating
system�
•
The Rinnai Continuous Flow water heater products NEVER RUN OUT of hot water� Whilst electricity, water
and gas supplies are connected, hot water is available whenever hot water taps are open�
•
Built into the main micro-processor is the facility to LIMIT THE MAXIMUM TEMPERATURE of the hot water
supplied� The water temperature may be limited to various values� This is particularly useful when the hot
water unit is installed where young children or the infirm may be using the hot water.
•
The Rinnai Continuous Flow water heater products are Fan-Assisted (power flued) appliances. This makes
them COMPACT, saving both floor and wall space.
•
The temperature of hot water is CONSTANTLY MONITORED by a BUILT-IN SENSOR� If the temperature
of the hot water rises to more than 3°C above the selected temperature the burner is turned OFF and only
turned ON again when the temperature falls below the selected temperature�
•
The burner lights automatically when the hot water tap is opened, and goes out when the tap is closed�
IGNITION IS ELECTRONIC, so there is no pilot light� When the hot water tap is off, no gas is used�
•
'Deluxe' or 'Universal' Water Controllers are available as an optional extra� Depending on the models chosen,
these offer the following features:
-
Bath fill function (Deluxe Bathroom Control Only).
-
Voice Prompting (Deluxe Control Only).
-
Clock (Deluxe Control Only).
-
Up to four water controllers can be fitted. See page 9 for details.

For further information regarding Wireless and Deluxe water controllers please contact Rinnai or visit
www�rinnai�com�au�
•
The "Smartstart®" system when fitted can pre-heat the water in the pipe-work between the water heater and
the hot water outlets� This results in water savings and reduces waiting time for heated water at the outlets�
•
Operating NOISE LEVEL IS VERY LOW�
•
ERROR MESSAGES ARE DISPLAYED on the Water Controllers and Status Monitor*, assisting with
service� *All models in the range covered by this manual have a "Status Monitor", except B16,B20 & B26�
•
The Infinity 26 Touch (REU-AM2626WDL) water heater model is supplied with one "MC-503" wireless
water controller that is pre-programmed as a master controller� Additional 'MC-503' wireless water controllers
are available as an optional extra� Please refer the separate wireless operation manual for instructions on
how to use the supplied wireless water controller�
Rinnai
WARNINGS & IMPORTANT INFORMATION
7 HW_CF OIM