Sharp MX-6580N User Manual page 885

SYSTEM SETTINGS►SYSTEM SETTINGS
Status
Errors that do not stop machine
operation, such as almost out of
toner.
Red
indicator Errors that stop machine
(Error operation, such as misfeeds
indicator) and out of toner.
The machine is in a status other
than the above.
Status Indicator will blink if data is received
Specify whether or not the status indicator blinks when a fax or Internet fax is received.
Total Setting for Finish
Select the finish setting. Set whether finishing positions are specified on the specified paper or on the original.
Auto Switching of Finisher Trays
When the Finisher Upper Tray is filled with papers, the output tray is switched to the Lower Output Tray automatically.
If the Finisher Lower Tray is selected for paper output, papers are output to the Finisher Lower Tray only.
Paper Weight Setting
These are used to control the toner fusing temperature according to the weight of the paper.
These settings apply to plain paper, recycled paper, punched paper, pre-printed paper, letterhead paper, colored paper,
and user type paper.
You can select "16 - 23 lbs." or "23+ - 28 lbs." ("60g/m
This can only be set on the machine's operation panel.
Be sure to use only paper that is in the same weight range as the weight range set here. Do not mix plain or other paper that
is outside the range with the paper in the tray.
When settings are changed, the changes will take effect after the machine is restarted. To restart the machine, see
"TURNING ON THE POWER (page
Data List
To specify [One Sided] or [Two Sided] printing in Data List.
Disabling of Duplex
This is used to disable 2-sided printing, such as when the duplex module malfunctions.
Disabling of Offset
Disable offset output.
Disabling of Stapler
This setting is used to prohibit the use of staple, such as when the staple of finisher or saddle stitch finisher
malfunctions.
Disabling of Punch
This setting is used to prohibit the use of punch, such as when the punch module of finisher or saddle stitch finisher
malfunctions.
Disabling of Color Mode
When a color-related problem has occurred and printing is not possible, the use of color mode will be temporarily
blocked.
Pattern 1
Red: Light up
Red: Blink
Red: Off
2 2
to 89g/m
1-10)".
8-132
Pattern 2
Red: Light up
Red: Blink
Red: Off
2 2
" or "90g/m to 105g/m ").
Pattern 3
Red: Light up
Red: Blink
Red: Off