Changing The Network Connection To Ethernet From The Control Panel; Disabling Wi-Fi From The Control Panel; Disconnecting Wi-Fi Direct (Simple Ap) Connection From The Control Panel - Epson XP-15000 Series User Manual

User's Guide
Changing the Network Connection to Ethernet from
the Control Panel
Follow the steps below to change the network connection to Ethernet from Wi-Fi using the control panel.
1. Select Settings on the home screen.
To select an item, move the focus to the item using the
2. Select Network Settings > Wired LAN Setup.
3. Press the OK button.
4. Connect the printer to a router using an Ethernet cable.

Disabling Wi-Fi from the Control Panel

When Wi-Fi is disabled, the Wi-Fi connection is disconnected.
1. Select Wi-Fi on the home screen.
To select an item, move the focus to the item using the
2. Select Wi-Fi (Recommended).
The network status is displayed.
3. Select Change Settings.
4. Select Others > Disable Wi-Fi.
5. Check the message, and then press the OK button.
6. When a completion message is displayed, press the OK button.
The screen automatically closes after a specific length of time.
7. Press the button.
Disconnecting Wi-Fi Direct (Simple AP) Connection
from the Control Panel
Note:
When Wi-Fi Direct (Simple AP) connection disabled, all computers and smart devices connected to the printer in Wi-Fi
Direct (Simple AP) connection are disconnected. If you want to disconnect a specific device, disconnect from the device
instead of the printer.
1. Select Wi-Fi on the home screen.
To select an item, move the focus to the item using the
Network Settings
u d l r
buttons, and then press the OK button.
u d l r
buttons, and then press the OK button.
u d l r
buttons, and then press the OK button.
39