Panasonic S-22KA1E5S Service Manual page 163

REMOTE CONTROL INSTALLATION PROCEDURE
•
Remove the remote control lower case.
(Insert a flat-tipped screw driver or similar 2 to 3
mm into one of the gaps at the bottom of the case,
and then twist the screw driver to open. [Refer to
the illustration on the right.])
Be careful not to damage the lower case.
•
Secure the lower case to the wall or outlet box.
(Refer to the illustration on the right for the
embedded and exposed positions for the remote
control cable.)
NOTE
* Do not remove the protective tape which is
affixed to the upper case circuit board.
•
If installing the remote control with the remote
control cable exposed, use nippers to cut a notch
into the upper case. (The feeding-out direction can
be either up or to the left or right)
•
Strip the end of the remote control cable which is
to be connected to the remote control. (Refer to
the illustration on the right)
•
Route the remote control cable inside the lower
case in accordance with the intended feeding-out
direction. (Refer to the illustration on the right)
Securely connect the connector CN1. (If it is not
connected, the remote control will not operate.)
NOTE
* After connecting the connector, do not suspend
the upper case by its own weight, otherwise the
connector cord may break.
Gaps
Lower
case
163
Upper case
Lower case
4 mm screws
(accessories)
Approx. 7 mm
Approx. 20 mm
Do not suspend the
upper case by its own
weight. (The connector
may break.)