Troubleshooting - Universal Electronics MillenNium 4 User Manual

TROublesHOOTinG

PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
PROBLEM: LED blinks when you press a key, but
SOLUTION: Make sure you are aiming the Millennium
PROBLEM: The Millennium 4 does not control home
SOLUTION: Try all listed codes for the component
PROBLEM: TV/VCR combo does not respond prop-
SOLUTION: Use the VCR codes for your brand.
PROBLEM: No volume on a second TV.
SOLUTION: Follow instructions in Changing Volume
PROBLEM: CH+ , CH – , and lasT do not work for
SOLUTION: Due to RCA design (1983-1987), only the
PROBLEM: Changing channels does not work properly.
SOLUTION: If original remote control required pressing
PROBLEM: Tried "Search Method" and still could not
SOLUTION: Try the "Search Method" again after clear-
alkaline batteries (see page 7).
home entertainment component does not
respond.
4 at your home entertainment component
and that you are within 15-feet of the com-
ponent you are
trying to control.
entertainment components or commands
are not performing properly.
brand being set up. Make sure all
components can be operated with an infra
red remote control.
erly.
Some combo units may require both a TV
code and a VCRcode for full operation
Lock.
your RCA TV.
originalremote control will operate these
functions.
ENTER to change channels, press enTeR
on the Millennium 4 after entering a chan
nel number.
find a working code.
ing out the device key as follows: Press and
hold enTeR until red light blinks twice,
then release. Next enter 9 - 9 - 2. Then
press and release the device
43