To Lock Volume Control To One Mode (Global Volume Lock); Troubleshooting - Universal Electronics ATLAS XL User Manual

Atlas XL Eng/Sp Manual
To Lock Volume Control To One Mode
(Global Volume Lock):
NOTE: The audio mode's volume controls are active regardless of
Volume Lock settings. However, if you lock the volume controls to
the AUD mode, you will have control of the audio device's volume
in all other modes (i.e., TV , VCR, and CBL).
1. On the remote control, press and hold SETUP
until the last-selected device key blinks twice,
then release SETUP.
2. Enter 9 - 9 - 3. The last-selected device key
will blink twice.
3. Select a mode (e.g., TV) where you want to
globally lock the volume controls. The select-
ed device key will blink twice.
4. Now, when you press VOL+, VOL–, or MUTE,
the volume of the selected device (e.g., TV)
can be controlled regardless of mode.

TROUBLESHOOTING

PROBLEM: Mode key does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 7).
PROBLEM: Mode key blinks when you press a key, but home
entertainment device does not respond.
SOLUTION: Make sure you are aiming the remote control at
your home entertainment device and that you
are within 15 feet of the device you are trying
to control.
PROBLEM: The remote control does not control home
entertainment devices or commands are not
performing properly.
SOLUTION: Try all listed codes for the device brand being set
up. Make sure all devices can be operated with
an infrared remote control.
PROBLEM: TV/VCR Combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo
units may require both a TV code and a VCR
code for full operation (see page 10).
4/21/03 4:21 PM Page 19
continued on next page...
19