National Instruments BNC-2090A User Manual page 48

front panel
and enclosure back, 1-2
highpass filter on differential
channel 1, 3-9
highpass filter on single-ended
channel 1, 3-9
installation, 1-3
lowpass filter on differential
channel 1, 3-7
M Series device connections, 1-5
normalized frequency response of
lowpass filter, 3-6
PFI 0 signals, 2-6
USER <1..2>
BNC connections, 2-7
example, 2-7
DIFF mode. See differential mode
differential mode
analog input signal conditioning
(figure), 3-2
attenuators use, 3-11
highpass filter (figure), 3-9
measuring floating signals, 2-2
measuring ground-referenced signals, 2-3
signals, 2-2
digital
ground jumper setting, 1-7
signals, 2-6
wire specifications, 2-6
disconnecting the shield from the DAQ ground
jumper setting, 1-7
documentation
conventions used in the manual, v
NI resources, C-1
drivers (NI resources), C-1
E
E Series
device connections, 1-6
diagram, 1-6
© National Instruments Corporation
enclosure back, 1-2
examples (NI resources), C-1
F
FAQs, B-1
features, 1-1
filters
analog input lowpass, 3-5
analog output
lowpass, 3-13
analog output highpass, 3-13
highpass, 3-7
note, 3-9
highpass on single-ended channel 1, 3-9
floating signals
measuring in differential mode, 2-2
measuring in single-ended mode, 2-4
frequently asked questions, B-1
front panel, 1-2
diagram, 1-2
G
ground-referenced signals
measuring in differential mode, 2-3
measuring in single-ended mode, 2-5
H
help, technical support, C-1
highpass filters, 3-7
analog output, 3-13
normalized frequency response, 3-8
note, 3-9
on differential channel 1, 3-9
on single-ended channel 1, 3-9
I-3
Index
BNC-2090A User Manual