National Instruments BNC-2090A User Manual page 47

Shielded rackmount bnc connector block for e/m series daq devices
Hide thumbs Also See for BNC-2090A:
Table of Contents

Advertisement

Index
attenuators, 3-10
with SCXI resistor kit, B-2
highpass filters, 3-7
lowpass filters, 3-5
voltage dividers, 3-10
C
cabling
to E Series devices, 1-6
to M Series devices, 1-5
calibration certificate (NI resources), C-2
capacitor
adding, 3-14
locations, 3-4
locations on highpass filters on
single-ended channel 1, 3-9
placement for lowpass filter on
differential channel 1, 3-7
population options, 3-5
channel component positions, 3-4
components
adding, 3-14
location for analog output signal
conditioning, 3-12
location for attenuator for use with
single-ended inputs, 3-11
locations for attenuator for use with
differential inputs, 3-11
locations on highpass filter on
single-ended channel 1, 3-9
placement for lowpass filter on
differential channel 1, 3-7
population options, 3-5
positions, 3-4
connecting
analog input signals, 2-1
analog output signals, 2-5
APFI 0 signals, 2-5
differential analog input signals, 2-2
digital signals, 2-6
BNC-2090A User Manual
digital/timing signals to a BNC, 2-7
PFI 0 signals, 2-5
signals, 2-1
single-ended analog input signals, 2-3
to E Series devices, 1-6
to M Series devices, 1-5
USER <1..2>, 2-7
connectors, USER <1..2> BNC, 2-7
conventions used in the manual, v
current measurement, B-2
D
Declaration of Conformity (NI resources), C-1
desoldering, 3-15
diagnostic tools (NI resources), C-1
diagram
100 Ω to digital ground shield ground
jumper setting, 1-7
accessing the shield ground jumper, 1-8
analog input normalized frequency
response of highpass filters, 3-8
analog input signal conditioning, 3-2
analog input single-ended mode signal
conditioning, 3-3
analog output
signals, 2-6
analog output signal conditioning, 3-12
APFI 0 signals, 2-6
attenuator for use with differential
inputs, 3-11
attenuator for use with single-ended
inputs, 3-11
BNC-2090A circuitry, 2-1
BNC-2090A disassembly, 3-14
differential mode, 2-2
digital ground jumper setting, 1-7
disconnecting the shield from the DAQ
ground jumper setting, 1-7
E Series device connections, 1-6
I-2
ni.com

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents